Projects/bitmobile: Difference between revisions
< Projects
mNo edit summary |
No edit summary |
||
| Line 12: | Line 12: | ||
== TODO == | == TODO == | ||
* Power: fix the batteryloader and maybe new batteries | * Power: fix the batteryloader and maybe new batteries | ||
* Frame: lasercut | Either build or buy a batteryloader | ||
* Frame: lasercut backframe for on the back, mount batteryloader on the back | |||
Design backframe | |||
Lasercut backframe | |||
* Cosmetics: spraypaint, mount LED strips and music system (amplifier+speakers) | * Cosmetics: spraypaint, mount LED strips and music system (amplifier+speakers) | ||
Paint new backframe, spinners and underside of the frontpanel | |||
* Electronics: fix lights | * Electronics: fix lights | ||
== Project timeline == | == Project timeline == | ||
Revision as of 14:46, 6 September 2015
 | |
|---|---|
| Project Bitmobile | |
| Name | Bitmobile |
| Start | 2014/05/18 |
| End | |
| Contact | Stijn |
| Website | |
| Information | Reviving the scootmobile used at OHM2013. |
| Status | Alpha |
Project description
See https://pad.bitlair.nl/p/bitmobile for ideas and planned modifications.
TODO
- Power: fix the batteryloader and maybe new batteries
Either build or buy a batteryloader
- Frame: lasercut backframe for on the back, mount batteryloader on the back
Design backframe Lasercut backframe
- Cosmetics: spraypaint, mount LED strips and music system (amplifier+speakers)
Paint new backframe, spinners and underside of the frontpanel
- Electronics: fix lights
Project timeline
21/05/2014
- Replaced the 6.35mm jack plug 'ignition' with a barrel plug
- Accidentally fried part of the controller board, causing the turn signals to stop functioning
22/05/2014
- Sanded the plastic body parts in preparation of painting
25/05/2014
- Painted some plastic body parts
- Replaced barrel plug 'ignition' with electronical lock (with key)
- Painted rims to prevent any further rust
- Laser-cut spinners to put on the rims
18/11/2014
- Kartoffel has acquired programming software
23/11/2014
- Success! We built a programming cable and were able to reprogram the motor controller. At this point we can change the acceleration and deceleration, but we haven't figured out how to increase the speed above 15km/h.
Pictures
